Saunagen PH-II Manual de instrucciones

Instruction Manual Thank you for choosing the SaunaGen infrared sauna! www.saunagen.com

9Control panels a. Unpack the CD player and Faceplate control from the box. Secure CD player to the small upper slot provided on front wall with d

10 Fig18 Fig19 Fig20 Fig21 Fig22 Fig23 h. Locate the control panel’s main wire A from the Power Board, and attach to the back of the ex

11 Speaker & Light Wiring: The speakers and the light are pre-wired to the power supply. Internal top ceiling & Power Outlet Wiring: a. Loc

12 a. Check all the circuitry and the plug meet all requirements. b. Set the temperature and time to a comfortable level, normally, 30 minutes at 4

13 d. Do not spray water on the far-infrared tube. This activity may result in electric shock or damage to the heater elements. e. Do not use the

14 Problem Explanation Solution The tube is defective. Replace with a new heat tube, and attach it by screwing in the nut and re-cover the heat

15 *** Do not leave the sauna or CD player on for more than 2 hours at a time. *** Transportation and storage 1. Avoid exposure to rain, snow

16 Limited warranty on SaunaGen Infrared Sauna replacement parts. SaunaGen warrants its products to be free from defects in material and workman

17 SaunaGen 8173 Belvedere Ave, Suite B Sacramento, CA 95826 Model (please circle one): 1-person Sauna 2-person Sauna 3 -per

1 Revision 1.02:071503 Index ===================================== Introduction, benefits, highlights 2 Installation requirements Ins

2 1. Introduction Welcome to SaunaGen and congratulations on your new path to better health! Thousands of users enjoy the benefits of infrare

3 Installation 1. Installation requirements a. Do not plug any other appliances into the outlet with your SaunaGen sauna. b. Install the sa

4 a. Open the sauna packaging in a large area. b. Place the bottom board (section 4) in the desired location of your sauna. The sauna will be

5Fig1 fig2 c. Place the front panel with door (section 3) on the front of the bottom panel. See Figure 2 Fig 3

6Fig4 Fig5 d. Place the left side wall (section 7) on the bottom, lift it in order to make the two pieces of pothooks lock on the corresponding

7 e. Locate back wall (section 8) and attached to the left side wall (Section 7) with the special latching system; See Figure 6 f. Locate right wal

8 Fig 12b j. Locate section 9 (ceiling panel), rise above the walls and set in place to complete the enclosure. The ceiling should fit easily.